Mixer

The mixer is used for controlling and adjusting the output parameters of your tracks to achieve the best mix for your project.

Each channel represents one track of your project. Its name is displayed at the bottom.

Each channel holds the following controls:

• Pan fader: Slide horizontally to adjust your track's stereo pan.
• Volume fader: Slide the volume fader vertically to set the track's gain. The volume levels during playback or recording are visually shown on its right hand indicator. The display at the bottom of the channel shows the fader's value in decibels (negative values mean a decrease in volume). Note: The pan and volume faders' value can be reset by double tapping them.
• Mute: Use this button to toggle whether the channel's track is muted and therefore excluded from playback.
• Solo: Soloing a track (or a group of tracks) excludes all the other tracks from playback.

• Read: When enabled, all automation data on this track is read and applied during playback.
• Write: Activate this button to record automation data live during playback / recording. More information on automation can be found here.
• Effects: Use this button to add effects to your track. This article explains how.
• Monitor recording (Audio tracks only): Monitoring plays back the audio input of your track while it's being recorded. Note: In order to prevent feedback, monitoring only works when external phones or a microphone is connected.
• Setting a track to Record Enable lets Cubasis know that you wish to record on this track. You can have multiple tracks Record Enabled at a time, which allows for recording on multiple tracks simultaneously.

MIDI and audio trac ks can be assigned to up to 24 individual outputs (12 stereo pairs) simultaneously. The number of available outputs depends on capability of the connected audio hardware. If no audio interface is connected, only 2 output channels (stereo pair 1/2) are available.

To assign specific outputs, tap the Output display (showing 1/2 by default) and toggle stereo outputs via the buttons in the output popup. This popup window can also be called up by tapping the output panel in the inspector's routing section.

The last channel to the right of your screen (labelled 1/2 Stereo Out) represents all of your project's channels combined and routes to the first stereo output pair (channels 1 and 2). Consequently, it cannot be soloed or recorded on. You can add three master insert effects, that are applied to the whole mix.

For more information, see the Effects chapter.

The metronome button is only available on the master channel and additional output channels. This option allows you to select the output destination(s) of the metronome. For instance, to output the metronome only on channel 5, select output 5 & 6 and either pan the metronome to the left (in the setup menu), or pan the output bus 5 & 6 to the left.